Setting SRT Codes
- If using CONSULT-II, go to next step. If using generic scan tool, go to step 3.
- Perform corresponding DTC CONFIRMATION TEST one by one based on PRIORITY in SRT PRIORITY table.
- To set all SRT codes as complete, drive vehicle according to procedure shown in illustration. See Fig 1. Perform driving procedure one or more times. If driving procedure is interrupted, repeat procedure.
- On A/T models, operate vehicle with shift lever in "D" position and overdrive turned on. On M/T models, shift gears at suggested speeds. See SUGGESTED SHIFT SPEEDS (M/T) table. DO NOT exceed maximum suggested speed in any gear. See MAXIMUM SPEED FOR EACH GEAR table.
SRT PRIORITY
| SRT Item (Display On CONSULT-II) | Required DTC Confirmation Test(s) | Priority |
|---|---|---|
| CATALYST | P0420 | 3 |
| EGR SYSTEM | P0400 | 3 |
| P1402 | 1 | |
| EVAP SYSTEM | P0440 | 2 |
| P1447 | 3 | |
| 02 SENSOR | P0130-P0134, P0137-P0140 | 3 |
| O2 SEN HEATER | P0135, P0141 | 3 |
SUGGESTED SHIFT SPEEDS (M/T)
| Gear Change | Shift Speed (MPH) |
|---|---|
| 1st To 2nd | 15 |
| 2nd To 3rd | 25 |
| 3rd To 4th | 40 |
| 4th To 5th | 45 |
MAXIMUM SPEED FOR EACH GEAR
| Gear | Speed (MPH) |
|---|---|
| 1st | 35 |
| 2nd | 60 |
| 3rd | 85 |