Without Nissan CONSULT Scan Tool (Mode V)
- To enter on-board diagnostic Mode V, turn ignition switch to LOCK position. Ensure gear selector lever is in Park. Turn ignition switch to RUN position, and within 5 seconds, push memory set switch and both memory switches at the same time for more than 2 seconds.
- Indicator lights on memory switches will illuminate and both seat and steering column will move to indicate successful entry into on-board diagnostic Mode V. Start engine as soon as indicator lights turn off, and within 15 seconds, drive vehicle at a speed greater than 4 MPH. This tests Vehicle Speed Sensor (VSS) circuit. Stop vehicle, leaving engine running.
- If a circuit malfunctions, a fault code is displayed by flashing indicator lights on memory switches No. 1 and 2. For example, a fault Code 3 is identified as 3 flashes. Each flash occurs in one second intervals. If a fault exists, perform corresponding diagnostic procedure. See the SELF-DIAGNOSTIC DIRECTORY
table. If no self-diagnostic faults are present, Mode V will end after VSS diagnosis is performed. Diagnosis will also end after self-diagnostic results have been indicated for 10 minutes if left unattended.
SELF-DIAGNOSTIC DIRECTORY
| Scan Tool Display (DTC) |
Diagnostic Procedure |
| SEAT SLIDE (1) |
5 & 11 |
| SEAT RECLINING (2) |
6 & 12 |
| SEAT LIFTER-FR (3) |
7 & 13 |
| SEAT LIFTER-RR (4) |
8 & 14 |
| STEERING TELESCO (7) |
4 & 10 |
| STEERING TILT (8) |
3 & 9 |
| VEHICLE SPEED SENSOR (9) |
19 |
| DETENT SW [PAST INPUT FAIL] (.....) |
19 |
| SEAT SLIDE [PAST OUTPUT FAIL] (.....) |
|
| SEAT RECLINING [PAST OUTPUT FAIL] (.....) |
|
| STEERING TILT [PAST OUTPUT FAIL] (.....) |
|
| TELESCO SEN [PAST] (.....) |
4 |
| TILT SEN [PAST] (.....) |
3 |