ECCS, ECM & Fuel Pump Relays

Two types of relays are used; 4-terminal and 6-terminal. For relay location, see Figure, Figure, Figure or Fig 1 . Remove appropriate relay. Apply battery voltage and ground to terminals No. 1 and 2. See Fig 2 or Fig 3 .
Continuity should exist between terminals No. 3 and 5. On 6-terminal relays, continuity should also exist between terminals No. 6 and 7. On all relays, when battery voltage is removed, continuity should not exist. Replace relay if test values are not as specified.

Fig 1: Locating Fuel Pump Relay (I30)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Identifying 4-Terminal Relay Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Identifying 6-Terminal Relay Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.