LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1998 >> Q45 Base >> Repair and Diagnosis >> Electrical >> Charging Systems >> Generator & Regulator - Except QX4 >> On-Vehicle Testing >> Generator Test

Generator Test

NOTE: Terminals "S", "L", "B", and "E" are marked on generator rear cover. Terminal "F" is an internal terminal.
  1. Ensure battery is fully charged. Ensure all fuses are in good condition. Check fusible link "A" in power distribution box. Power distribution box is located in front left corner of engine compartment. If fusible link is okay, go to next step. If fusible link is blown, check for short to ground in Brown/Red wire between power distribution box and generator and repair as necessary.
  2. Turn ignition switch to RUN position. Observe CHARGE light on instrument panel. If CHARGE light does not illuminate, go to next step. If CHARGE light illuminates, go to step  4.
  3. Disconnect terminals "S" and "L" at generator. Using a fused jumper wire, ground terminal "L" at harness. If CHARGE light does not illuminate, check the following and repair as necessary: CHARGE light bulb, blown warning light fuse and/or damaged wiring. If light illuminates, replace IC regulator.
  4. Start engine and raise engine speed to 1500 RPM. If CHARGE light does not illuminate, system is okay at this time. If light illuminates, go to next step.
  5. Turn engine off. Check drive belt tension, connections at terminals "B", "S" and "L" at generator, and fuse for terminal "S". If problem does not exist, go to next step. If problem exists, repair as necessary.
  6. Start engine and allow it to idle. If CHARGE light is illuminated, go to next step. If CHARGE light is not illuminated, system is okay at this time.
  7. Raise engine speed to 1500 RPM. Measure voltage at terminal "B" at generator. If greater than 15.5 volts exists, replace IC regulator. If less than battery voltage exists, field circuit is open. Repair or replace generator as necessary.