SRS Control Module (SRSCM): Installation

Install in the reverse order of removal.
NOTE:
- After installing the SRSCM, Carry out variant coding.
  (Refer to SRS Control Module (SRSCM) - "VARIANT CODING ")
- After installing the SRSCM, Carry out longitudinal G-sensor calibration.
  (Refer to SRS Control Module (SRSCM) - "ZERO SETTING ")
- When replacing OTA controller, use the diagnostic device to update S/W. (If the S/W update is not complete, OTA update is not possible.)
  (Refer to Body (Interior/Exterior/Electrical) - "OVER THE AIR (OTA) ")
Information
- Turn the power switch ON; the SRS indicator light should be turned on for about 3 - 6 seconds and then go off.