ETC Module Learning Procedure
WARNING: This page is about a different car, the 2024 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
When replacing new ETC module or re-installing it, ETC module learning procedure must be performed.
- Hold the ignition key or the start button at the IG ON position for 1 minute.
- After starting the engine, keep the idle state for 15 minutes.
- Turn the ignition key or the start button off and hold for 1 minute.
- Re-start the engine and check the idle roughness.
NOTE:
- Related DTC codes might be displayed if ETC module learning procedure is not performed after replacing ETC module.