Repair Procedures: Installation
CAUTION:
- Note the value (A) carefully and check the value again before assembly.
- Inputting an invalid value may cause the abnormal shifting shock while TCM learning.
- To install, reverse the removal procedure.
- Inject the automatic transaxle oil and inspect the oil level. (Refer to Automatic Transaxle System - "AUTOMATIC TRANSAXLE FLUID ")
- Clear the diagnostic trouble codes (DTC) using the diagnostic tool.CAUTION:
- Even though disconnecting the battery negative terminal, the DTCs will not be cleared. So, be sure to clear the DTCs using the diagnostic tool.
- Reset the automatic transaxle adaptive values using the diagnostic tool.
- Input the oil pressure characteristics using the diagnostic tool.
- In order to prevent start delay and gear shift shock during acceleration and start, perform TCM learning after replacing the solenoid valve. (Refer to Automatic Transaxle Control System - "TCM LEARNING ")