LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Venue SEL >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules And Clock Spring >> Side Airbag (SAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

CAUTION:
  • Be sure to install the harness wires not to be pinched or interfered with other parts.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Disconnect the battery negative cable and wait for at least three minutes.
  4. Install the side airbag.

    Tightening torque: 

    6.0-7.8 N.m (0.6-0.8 kgf.m, 4.4-5.8 lb-ft)

  5. Install the front seat back cover.

    (Refer to Body - "FRONT SEAT BACK COVER ")

    NOTE:
    • Make sure that the seat back cover is installed properly. Improper installation may prevent the proper deployment.
  6. Install the front seat assembly.

    (Refer to Front Seat - "FRONT SEAT ASSEMBLY ")

  7. Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
  8. Reconnect the battery negative cable.
  9. After installing the side airbag (SAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals