LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Venue SEL >> Repair and Diagnosis >> Electrical >> Gauges >> Crash Pad >> Main Crash Pad Assembly >> Repair Procedures >> Replacement

Repair Procedures: Replacement

CAUTION:
  • Put on gloves to prevent hand injuries.
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front pillar trim.

    (Refer to Interior Trim - "FRONT PILLAR TRIM ")

  3. Remove the floor console assembly.

    (Refer to Floor Console - "FLOOR CONSOLE ASSEMBLY ")

  4. Remove the crash pad lower panel.

    (Refer to Crash Pad - "CRASH PAD LOWER PANEL ")

  5. Remove the cluster fascia panel.

    (Refer to Crash Pad - "CLUSTER FASCIA PANEL ")

  6. Remove the center fascia panel.

    (Refer to Crash Pad - "CENTER FASCIA PANEL ")

  7. Remove the audio and AVN head unit.

    (Refer to Body Electrical System - "AUDIO UNIT ")

  8. Remove the crash pad center panel.

    (Refer to Crash Pad - "CRASH PAD CENTER PANEL ")

  9. Remove the steering column shroud lower panel.

    (Refer to Crash Pad - "STEERING COLUMN SHROUD PANEL ")

  10. Remove the steering wheel.

    (Refer to Steering System - "STEERING WHEEL ")

  11. Remove the multifunction switch assembly.

    (Refer to Body Electrical System - "MULTIFUNCTION SWITCH ")

  12. Remove the instrument cluster.

    (Refer to Body Electrical System - "INSTRUMENT CLUSTER ")

  13. Remove the heater & A/C control unit.

    (Refer to Heating, Ventilation, Air Conditioning - "HEATER AND A/C CONTROL UNIT ")

  14. Using a flat-tip screwdriver and remove the photo sensor (A).
    G14695739Courtesy of HYUNDAI MOTOR AMERICA
  15. Separate the connector and remove the photo sensor (A).
    G14695740Courtesy of HYUNDAI MOTOR AMERICA
  16. Loosen the mounting screws and remove the crash pad garnish (A).
    G14695741Courtesy of HYUNDAI MOTOR AMERICA
  17. Press the lock pin and separate the crash pad garnish connector (A).
    G14695742Courtesy of HYUNDAI MOTOR AMERICA
  18. Using a remover, open the cover and loosen the PAB mounting nuts (A).

    Tightening torque: 

    6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft)

    G14695743Courtesy of HYUNDAI MOTOR AMERICA
  19. Loosen the mounting bolts and nuts and remove the main crash pad assembly (A).

    Tightening torque: 

    6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft)

    G14695744Courtesy of HYUNDAI MOTOR AMERICA
  20. Press the lock pin and separate the passenger's airbag connectors (A).
    G14695745Courtesy of HYUNDAI MOTOR AMERICA
  21. To install, reverse removal procedure.

    Information 

    • Make sure the connector is connected properly.
    • Replace any damaged clips (or pin-type retainers).
scientia non olet · About LEMON Manuals