LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Venue Denim >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine And Transaxle Assembly (R & I) >> Engine Mounting >> Repair Procedures >> Removal and Installation >> Transaxle mounting bracket

Transaxle mounting bracket

  1. Disconnect the battery negative terminal.
  2. Remove the engine room under cover.

    (Refer to Engine and Transaxle Assembly - "ENGINE ROOM UNDER COVER ")

  3. Remove the air duct and air cleaner assembly.

    (Refer to Intake and Exhaust System - "AIR CLEANER ")

  4. Remove the battery.

    (Refer to Engine Electrical System - "BATTERY ")

  5. Remove the engine control module (ECM).

    (Refer to Engine Control/Fuel System - "ENGINE CONTROL MODULE (ECM) ")

  6. Remove the battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  7. Install the jack under the transaxle to support it.
    G14693780Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Insert the rubber block between jack and transaxle.
  8. Remove the service cover (A).
    G14693781Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the transaxle support bracket mounting bolts (A).

    Tightening torque: 

    107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 36.2 - 47.0 lb-ft)

    G14693782Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the transaxle mounting bracket (A).

    Tightening torque: 

    49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

    G14693783Courtesy of HYUNDAI MOTOR AMERICA
  11. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals