Repair Procedures: Installation
- Install the wiper motor.
- Install the crank arm.
Tightening torque:
13.0 -13.5 Nm (1.33 - 1.38 kgf.m, 9.6 - 10.0 lbf.ft)
CAUTION:- To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkages exactly.
- Install the lower and upper linkage to the wiper motor crank arm.
- Install the wiper motor and linkage assembly and then connect the wiper motor connector.
Tightening torque:
6.9 - 10.8 Nm (0.7 - 1.1 kgf.m, 5.1 - 8.0 lbf.ft)
- Install the cowl top cover.
- Install the windshield wiper arm and blade.
Tightening torque:
22.5 - 26.5 Nm (2.3 - 2.7 kgf.m, 16.6 - 19.5 lbf.ft)
NOTE:- The windshield wiper motor must be cycled to make sure that it is in the park position.
If necessary, adjust the wiper arm and blade.
- The windshield wiper motor must be cycled to make sure that it is in the park position.
- Install the wiper arm and blade to the specified position.
Auto stop position (Blade)