LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System - 2.5L (Except HEV)) >> Injector >> Repair Procedures >> Removal >> MPI Injector

MPI Injector

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  3. Disconnect the injector connector (A).
    G14534259Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel feed quick-connector (A).
    G14534260Courtesy of HYUNDAI MOTOR AMERICA
    G14534261Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Open the clamp cover (A) before disconnecting the quick-connector. (If the clip is applied)
      G14534262Courtesy of HYUNDAI MOTOR AMERICA
    • When removing the quick-connnector with the clip removing tool (A), be careful not to damage the plastic clip (B).
    • If the clip is damaged, it can cause a fuel leak due to bad connection and could result in a fire.
      G14534263Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the delivery pipe after loosening the mounting bolt (A).

    Tightening Torque: 

    18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.3 lb-ft)

    G14534264Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the injector from the delivery pipe (A) after releasing the fixing clip both side as shown below.
    G14534265Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals