LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System - 2.5L (Except HEV)) >> E-CVVT Motor >> Repair Procedures >> Removal >> E-CVVT Cover

E-CVVT Cover

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine mounting bracket.

    (Refer to Engine Mechanical System - "ENGINE MOUNTING ")

  2. Remove the engine support bracket (A) after loosening the mounting bolt.
    IMPORTANT:
    • Loosen the bolts in the sequence shown (6→5→4→3→2→1).
    Fig 1: Engine Support Bracket Bolts Loosening Sequence
    G14534302Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the E-CVVT cover connector (A).
    G14534303Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the E-CVVT cover (A) after loosening the mounting bolt.
    G14534304Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Take care avoid external force to the brush after removing the cover.
scientia non olet · About LEMON Manuals