Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
Information
- With the ignition off, press the brake pedal and press the "N" button (A) for 3 seconds.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- Remove the electronic shift actuator.
(Refer to Automatic Transaxle Control System - "ELECTRONIC SHIFT ACTUATOR ")
- Disconnect the position sensor connector (A).
- Loosen the mounting bolts (A) and then removing the position sensor (B).