| C1290 |
Torque sensor signal error |
Check after erasing the DTC, Check torque sensor, MDPS power pack connector |
Replace short gear |
| C1112 |
Torque sensor voltage error |
|
In case of reoccurrence, replace MDPS power pack |
| C1705 |
ECU over/discharge error |
| C1604 |
ECU hardware error |
| C2413 |
ECU hardware error |
| C2400 |
Motor signal error |
| C2401 |
Motor circuit error |
| C2412 |
Motor voltage supply error |
Check after erasing the DTC, Check ECU/motor connector |
|
| C1259 |
Steering angle signal error |
Check after resetting Steering angle zero point |
|
| |
|
Check connector connection condition |
|
| C1261 |
Steering angle signal error |
Check after resetting Steering angle zero point |
Reset Steering angle zero point |
| C1102 |
Battery voltage low |
Check battery voltage condition |
Recharge battery voltage. |
| C1696, C1697 |
SPAS signal error |
Check SPAS |
Erase DTC (MDPS is not to be replaced). |
| C1612, C1646 |
TCU signal error |
Check TCU |
|
| C1628, C1633, C1656 |
Clutster signal error |
Check cluster |
|
| C1692, C1693 |
VSM signal error |
Check VCM |
|
| C1260 |
Steering angle signal error |
Check after resetting steering angle zero point |
Reset Steering angle zero point |
| |
|
If C1259 does not occur, check CAN line. |
Erase DTC |
| C1611 |
CAN TIME OUT EMS |
1. Check G-SCAN condition |
Check engine ECU, chassis CAN line |
| C1613 |
Engine signal error |
2. Check connector connection |
Check EMS (Engine ECU) |
| C1616 |
CAN BUS OFF |
3. Check ECU CAN connector. |
Check chassis CAN line |
| C1622 |
Vehicle speed signal error |
4. Check MDPS ground line |
Check EMS (Engine ECU) |
| C1814 |
CAN SAS signal error |
Check SAS unit |
Erase DTC |
| C1704 |
ECU relay error |
Check after erasing the DTC, Check ECU connector |
In case of reoccurrence, replace MDPS power pack |
| C1659 |
CAN SAS signal not entered |
Check SAS UNIT, chassis CAN line. |
Erase DTC |
| C1804 |
LKAS signal not entered |
Check LKAS ECU |
Erase DTC |
| C1805 |
LKAS signal error |
|
|
| C1812 |
GATEWAY signal not entered |
Check engine ECU CAN line |
Erase DTC |
| C1817 |
GATEWAY signal error |
|
|
| C1704 |
ECU relay error |
Check after erasing the DTC, Check ECU connector |
In case of reoccurrence, replace MDPS power pack |