Repair Procedures: Installation
WARNING:
- Do not use already used injector fixing clip again.
WARNING:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
WARNING:
- Apply engine oil to the injector O-ring.
- Do not use already used injector O-ring again.
WARNING:
- Do not use already used bolt again.
WARNING:
- When insert the injector, be careful not to damage the injector tip.
- Install in the reverse order of removal.
Delivery pipe installation bolt :
18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)
High pressure fuel pipe installation nut :
29.4 - 35.3 N.m (3.0 - 3.6 kgf.m, 21.7 - 26.0 lb-ft)