LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Ioniq Plug-In Hybrid Limited >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Wheel (PHEV) >> Repair Procedures >> Removal And Installation

Removal And Installation

  1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
  2. Turn the steering wheel so that the front wheels are placed in the straight ahead position.
  3. Remove the driver airbag module (DAB).
    G13563714Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Insert the end of the flat tool along the guide hole. ( 5 mm allen wrench recommend.)
    • After inserting the tool, lightly press it. Can be easily remove the air bag module.
  4. Disconnect the airbag module connector (A) and horn connector (B).
    G13563715Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
  5. Disconnect the connector (A).
    G13563716Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the steering wheel by loosening the lock bolt.
    G13563717Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Do not reuse the steering lock bolt.
    • When assembling, match the gear teeth as the illustration below.
      G13563718Courtesy of HYUNDAI MOTOR AMERICA
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals