Repair Procedures: Installation

Install in the reverse order of removal.
Fill with engine coolant.
(Refer to Cooling System - "COOLANT ")

NOTE:

The coolant must be injected according to the Integrated Thermal Management Module (ITM) coolant filling method.

Perform the following

Refill the transaxle with fluid.
Inspect for fuel leakage.

After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.

Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.