Component Inspection

1. Connect a GDS to DLC (Data Link Cable).
2. Turn the ignition switch ON.
3. Actuate the "TMM" using the GDS.
4. Does the actuation work properly? Is the sensor output normal?

Specification:  Refer to MONITORING CURRENT DATA 

YES 

• Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR ".

NO 

• Replace the TMM motor with an usable one and check for proper operation. If the problem is corrected, replace the TMM motor and then go to "VERIFICATION OF VEHICLE REPAIR ".