Front Door Lock Module Inspection
- Remove the front door trim.
(Refer to Body - "FRONT DOOR TRIM ")
- Remove the front door module.
(Refer to Body - "FRONT DOOR MODULE ")
- Disconnect the connector from the actuator.CENTRAL LOCK - PIN INFORMATION
No Pin Information LH RH 1 - AJAR switch 2 Motor 1 COM 3 Motor 2 Lock/Unlock switch 4 - - 5 - - 6 Lock/Unlock switch Motor 2 7 COM Motor 1 8 AJAR switch - DEAD LOCK - PIN INFORMATIONNo Pin Information LH RH 1 Motor 1 AJAR switch 2 Motor 2 COM 3 Motor 3 Lock/Unlock switch 4 Key unlock switch Key lock switch 5 Key lock switch Key unlock switch 6 Lock/Unlock switch Motor 3 7 COM Motor 2 8 AJAR switch Motor 1 - Check actuator operation by connecting power and ground as shown below. To prevent damage to the actuator, apply battery voltage only momentarily.
Central Lock (Without key switch)
Dead Lock (Without Key Switch)
Dead Lock (With Key Switch)
Central Lock
CENTRAL LOCK OPERATION DESCRIPTION (LH/RH)Operation Central Lock Central Unlock Terminal 2 (7) + (-) -(+) 3 (6) -(+) +(-) 6 (2) & 7 (3) ON → OFF OFF → ON 7 (1) & 8 (2) Door open & Hall-latching (1st detent) = ON Full-latching (2nd close) = OFF [Dead Lock]
DEAD LOCK OPERATION DESCRIPTION (LH/RH)Operation Central Lock Central Unlock Dead Lock Dead Unlock Terminal 1 (8) - + + - 2 (7) + - - + 3 (6) - + - + 6 (2) & 7 (3) ON → OFF OFF → ON 7 (1) & 8 (2) Door open & Half latching (1st detent) = ON Full-latching (2nd close) = OFF