LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2019 >> Santa Fe SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Transfer Assembly) >> Transfer Fluid >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2020 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.

Information 

  1. Remove the under cover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  2. Loosen the oil filler plug (A).
    G12992499Courtesy of HYUNDAI MOTOR AMERICA
  3. Check the oil level.

    Information 

    • Oil level must be up to fill the hole, if not, add oil until it runs over.
    G12992500Courtesy of HYUNDAI MOTOR AMERICA
  4. Install the oil filler plug with new gasket.

    Tightening torque: 

    39.2 - 58.8 N.m (4.0 - 6.0 kgf.m, 28.9 - 43.4 lb-ft)

  5. Install the under cover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")