Repair Procedures: Removal

Pull the knob (A) in the direction of "F" and remove the knob.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the floor console assembly.
(Refer to Body - "FLOOR CONSOLE ")
Remove the air duct (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A) from the shift lever.

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the fixing clip (A) of wiring.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the snap pin (A).

Courtesy of HYUNDAI MOTOR AMERICA

Disconnect the control cable.

Disconnect the cable holer (A) from the shift lever.

Disconnect the cable bracket (B) from the shift lever after pushing the lock.

G12604048

Courtesy of HYUNDAI MOTOR AMERICA

G12604049

Courtesy of HYUNDAI MOTOR AMERICA

Remove the bolts and then shift lever assembly (A).
Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Remove the P position switch mounting bracket (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the P position switch (A) and shift lock solenoid (B).
Disconnect the main connector (C) from the shift lever.

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the manual mode switch housing (A).

Courtesy of HYUNDAI MOTOR AMERICA
P position switch, shift lock solenoid, manual mode switch housing, main connector assembly (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the mounting bracket (A) of terminals from the main connector.

Courtesy of HYUNDAI MOTOR AMERICA
Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
CAUTION: Record the location of the wiring colors before disconnecting the terminals.

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Connector information