Items to Check

Inspect DTC code.
Inspect whether N setting matches.
- Adjust N setting
  (Refer to Automatic Transaxle System - "INHIBITOR SWITCH ")
Inspect shift cable separation.
- Adjust shift cable separation.
  (Refer to Automatic Transaxle System - "SHIFT CABLE ")
Inspect whether connector is connected.
- Inspect connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
Turn ignition key "ON" and engine "OFF" and measure the power supplied to inhibitor switch circuit and voltage between ground.

Specification: approx. 12V
- Fix the pin wiring when connector pin wiring is faulty.
  (For wiring diagram information, refer to appropriate SYSTEM WIRING DIAGRAMS article). )
Inspect ground condition on reversing light circuit.
- Check the ground location of reversing light (refer to appropriate SYSTEM WIRING DIAGRAMS article).
- Reattach reversing light if ground condition is faulty.

Inspect wiring connection on junction box power terminal and fuse lamp.

Check whether fuse holder is separated and holder is holding the fuse tight.

Courtesy of HYUNDAI MOTOR AMERICA

Attach tester fuse to check if it is connected appropriately.

Courtesy of HYUNDAI MOTOR AMERICA

Check whether fuse capacity is appropriate for each circuit.
Check if fuse is damaged.
Check pulling of fuse fixing wiring, inflow of foreign substance, and arrangement condition of terminal.
Relocate the terminal that has been pulled and inspect using the method explained above.
When problem is not solved, refer to the appropriate SYSTEM WIRING DIAGRAMS article to fix or replace the terminal. .

Inspect inhibitor switch signal.
- Turn ignition key "ON" and engine "OFF".
- Measure the voltage between each terminal and chassis ground when shifting lever to "P, R, N, D" range.
  Specified value: refer to "signal code" table under "Specifications "