Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.

Remove the valve body assembly.
(Refer to Valve body System - "VALVE BODY ")
Disconnect the input & output speed sensor connector (A).
Loosen the main connector bolts (B).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 1: Disconnecting Input & Output Speed Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the solenoid valve connector (A).
1. Press the lock
2. Pull up lever
Fig 2: Disconnecting Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve connector mounting clip (A).

Fig 3: Removing Solenoid Valve Connector Mounting Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve connector (A) by pushing down from the transaxle.

Fig 4: Removing Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the O-Ring (A) before reinstalling solenoid valve connector.
Fig 5: Locating O-Ring
Courtesy of HYUNDAI MOTOR AMERICA