LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson SEL Plus, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Engine Control System - 2.0L) >> Intake Air Temperature Sensor (IATS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the manifold absolute pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor from the surge tank.
Fig 1: Locating Intake Air Temperature/Manifold Absolute Pressure Sensor Connector And Installation Bolt
G12044307Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals