LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson SEL Plus, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Engine Control System - 1.6L) >> Boost Pressure Sensor (BPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Disconnect the boost pressure sensor connector (A).
  4. Remove the installation bolts (B), and then remove the sensor.
Fig 1: Locating Boost Pressure Sensor Connector And Installation Bolts
G12039370Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals