Repair Procedures: Disassembly

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the M-terminal on the starter solenoid assembly.

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the 3 screws (A), detach the starter solenoid assembly (B).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the through bolts (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the brush holder assembly (C) the yoke (B) the armature (A) and the rear housing (D).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the shield (A) and packing (B).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the lever plate (A) and lever packing (B).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the planet gear (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the planet shaft assembly (A) and lever (B).

Courtesy of HYUNDAI MOTOR AMERICA
Press the stopper (A) using a socket (B).

Courtesy of HYUNDAI MOTOR AMERICA
After removing the stop ring (A) using stop ring pliers (B).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the stopper (A), overrunning clutch (B), internal gear (C) and planet shaft (D).

Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Using a suitable pulling tool (A), pull the overrunning clutch stopper (B) over the stop ring (C).

Courtesy of HYUNDAI MOTOR AMERICA
Reassembly is the reverse of disassembly.