Function Of Safety Power Window: Notes

When driver door power window auto-up switch is operated, safety function is activated.

1. Safety function condition

   When detect the force of 100 N.m (using the 10 N/mm spring) during the window rising, window is reversed.

2. Length of window reversing (except holding the auto-up switch)
   • When detect the jamming during the 4 mm ~ 250 mm from top of the door.

     → Window is reversed until 300 mm from top of the door.

     Fig 1: Checking Window Reversing Length (300MM)

     Courtesy of HYUNDAI MOTOR AMERICA
   • When detect the jamming over the 250 mm from top of the door.

     → Window is reversed until 20 mm from jamming position.

     Fig 2: Checking Window Reversing Length (250MM)

     Courtesy of HYUNDAI MOTOR AMERICA
3. Length of window reversing (holding the auto-up switch)
   • When detect the jamming during holding the auto-up switch.

     → Window is reverse until 25 mm from jamming position.

   • Auto-up function is not available during the 5 seconds from above condition.

     → When holding the auto-up switch, window is operated as a manual-up function. (Safety function is not activated.)

   • When holding the auto-up switch after 5 seconds from above condition.

     → Window is reverse until 25mm from jamming position.

     Fig 3: Checking Window Reversing Length (25MM)

     Courtesy of HYUNDAI MOTOR AMERICA
4. Safety function is not available area

   Safety function is not available during the 4 mm from top of the door.