Repair Procedures: Removal
- Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
NOTE:- Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
- Remove the parking brake cable.
(Refer to "PARKING BRAKE ASSEMBLY ")
- Loosen the nuts & bolts and then remove the trailing arm (A) with the rear axle.
Tightening torque
Trailing arm:
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
Parking brake cable bracket:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
- Loosen the mounting bolt and then remove the trailing arm (A) with the frame.
Tightening torque:
98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)
- Installation is the reverse of removal.
- Check the rear alignment.
(Refer to "REAR ALIGNMENT ")