Repair Procedures: Installation
WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
- Pre-tighten the bracket fixing bolt (A) in dash panel.
- Install the brake booster and brake pedal member fixing nuts (A) securely.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
- Tighten the bolt (A) securely in dash panel.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
- Install the snap pin (A) and clevis pin (B).NOTE:
- Before installing the pin, apply the grease to the clevis pin.
- Use a new snap pin whenever installing.
- Install the stop lamp switch securely.
- Connect the stop lamp switch connector (A).
- Adjust the brake pedal height and free play.
- Check the brake pedal operation after installing the brake pedal.
- Install the shower duct (A).
- Install the crash pad lower panel.
- Reconnect the battery negative cable.