Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.

Set shift lever to "N" position.
Remove the air duct.
(Refer to "AIR CLEANER ")
Remove the battery and the battery tray.
(Refer to "BATTERY ")
Disconnect the inhibitor switch connector (A).
Remove the shift cable mounting nut (B).
Tightening torque:

7.8~11.8 N.m (0.8~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

Remove the manual control lever (B) and the washer after removing a nut (A).

Tightening torque:

17.7~24.5 N.m (1.8~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Use a SST (09480-A3800) or 0.1969in.(5mm) bolt fix the inhibitor manual control lever in the N jig hole (A) when you assemble the inhibitor (B).

Courtesy of HYUNDAI MOTOR AMERICA

Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When installing, tighten the inhibitor assembly mounting bolt to the specification shown above.