System Components

Fig 1: PLG Unit

Courtesy of HYUNDAI MOTOR AMERICA

PLG unit is located in rear left luggage side trim.

PLG drive unit drive the two actuators (Spindles) by measuring the driving motors.

PLG unit also controls anti trap functions by hall sensor analysis in the anti-pinch strip.

Fig 2: Locating Power Latch And Power Closing Unit

Courtesy of HYUNDAI MOTOR AMERICA

PLG latch assembly is consist of Power Latch (A) and Power Closing Unit (B).

Power latch is located in the lower part of liftgate panel.

Fig 3: PLG Spindle Related Components

Courtesy of HYUNDAI MOTOR AMERICA

PLG spindle open and close the liftgate by driving the motor.

Fig 4: Anti-Pinch Strip

Courtesy of HYUNDAI MOTOR AMERICA

During power closing or cinching, the PLG system shall reverse to full open if an anti-pinch strip signal is received. However, the anti-pinch strips will not work when the Liftgate is idle in the full closed, full open, or stopped positions.

Fig 5: Smart Key

Courtesy of HYUNDAI MOTOR AMERICA

Push the power liftgate open of the SMK more than 0.5s to open the power liftgate. Power Open operation shall be reversed when an additional Open/Close signal is received during power opening.

Fig 8: Liftgate Buzzer

Courtesy of HYUNDAI MOTOR AMERICA

When a power operation cannot be performed as requested or an obstacle has been detected.