Blind Spot Detection - Left DTCS
BLIND SPOT DETECTION - LEFT DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1101 | 17: Battery Voltage High |
| DTC C1102 | 16: Battery Voltage Low |
| DTC C120A | 11: LED Right Circuit Short to Ground |
| DTC C120B | 15: LED Right Circuit Short to Battery or Open |
| DTC C120C | 11: LED Left Circuit Short to Ground |
| DTC C120D | 15: LED Left Circuit Short to Battery or Open |
| DTC C1501 | 01: Switch Failure |
| DTC C160A | 88: Local CAN bus off |
| DTC C1616 | 88: C-CAN Bus OFF |
| DTC C1625 | 87: CAN Time-out ABS/ESC (ESP) |
| DTC C1628 | 87: CAN Time-out Cluster |
| DTC C1633 | 81: Cluster Invalid Displayed Speed |
| DTC C1671 | 81: Signal 'Yaw_Rate' not valid |
| DTC C1675 | 81: Signal WHEEL_FL or WHEEL_FR or WHEEL_RL or WHEEL_RR not Valid |
| DTC C1702 | 55: RIGHT Control Module Slave Missing Calibration |
| DTC C170A | 11: Activation Switch LED Circuit short to ground |
| DTC C170B | 12: Activation Switch LED Circuit short to battery |
| DTC C170C | 04: ECU Hardware error (REAR RIGHT) |
| DTC C170D | 04: ECU Hardware error (REAR LEFT) |
| DTC C1812 | 87: CAN Time-out Gateway |
| DTC C1816 | 87: CAN time-out SJB |
| DTC C1824 | 81: CAN time-out CGW1 |
| DTC C2702 | 54: Left Control Module Missing Calibration |
| DTC C2703 | 54: Right Control Module Slave Missing Calibration |
| DTC C2706 | 42: Software version LH/RH unmatching |