Repair Procedures: Reassembly

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot.
Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).

Fig 1: Installing Spider Assembly And Snap Ring On Driveshaft Splines (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Installing Spider Assembly And Snap Ring On Driveshaft Splines (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Add specified grease to the joint boot as much as it was wiped away at inspection.
Install the both boot band.
Using the SST (09495-39100), secure the TJ boot bands.

Fig 3: Securing TJ Boot Bands Using Special Service Tool (09495-39100) (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Securing TJ Boot Bands Using Special Service Tool (09495-39100) (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Do not reuse the boot band.
Install the front driveshaft.
(Refer to Driveshaft Assembly - "FRONT DRIVESHAFT ")
Check the front alignment.
(Refer to Front Alignment - "ALIGNMENT ")