Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

Fig 1: Fixing Brake Pedal Arm And Inserting Stop Lamp Switch
Courtesy of HYUNDAI MOTOR AMERICA
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate by pushing.

Fig 2: Turning Stop Switch 45° Clockwise
Courtesy of HYUNDAI MOTOR AMERICA
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance: 1.0 - 2.0 mm (0.04 - 0.08 in.)

Fig 3: Checking Gap Between Stop Lamp Switch And Bracket
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- If the gap between stop lamp switch and bracket is not 1.0-2.0 mm (0.04-0.08 in), perform the above process again.
Connect the stop lamp switch connector.
Install the lower crash pad.
(Refer to Body - "CRASH PAD ")