Repair Procedures: Removal

Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the lower crash pad.
(Refer to - "Crash Pad Lower Panel ").
Disconnect the stop lamp switch connector (A).

Fig 1: Locating Stop Lamp Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Pull the locking plate (A) as indicated by the arrow.

Fig 2: Locating Locking Plate
Courtesy of HYUNDAI MOTOR AMERICA
Turn stop lamp switch 45° counterclockwise and remove it.

Fig 3: Turning Stop Lamp Switch 45° Counterclockwise
Courtesy of HYUNDAI MOTOR AMERICA

Inspect a removed stop lamp switch along the below procedures.

Confirm a normal connection with terminal part
- A confirmation can be made to ensure the connector has been secured properly and if a connection mark is present. Refer to (Fig 4).
Fig 4: Inspecting Removed Stop Lamp Switch For Normal Connection With Terminal Part
Courtesy of HYUNDAI MOTOR AMERICA
Perform the inspection of parts resistance

Fig 5: Inspecting Removed Stop Lamp Switch Parts Resistance
Courtesy of HYUNDAI MOTOR AMERICA

Resistance (Ω)	3-4	1-2
Non rod protruded (switch turned OFF)	Infinite	0
Rod protruded (switch turned On)	0	Infinite