Repair Procedure: Removal

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery cable.
Disconnect the brake fluid level switch connector.

Fig 1: Disconnecting Brake Fluid Level Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the brake fluid from the master cylinder reservoir with a syringe.
NOTE:
- Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
Remove the wheel & tire.
Remove the brake hose clip (A).
Disconnect the brake tube by loosening the tube flare nut (B).
Tightening torque:

12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)

[Front]

Fig 2: Removing Front Brake Hose Clip
Courtesy of HYUNDAI MOTOR AMERICA

[Rear]

Fig 3: Removing Rear Brake Hose Clip
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the brake hose by loosening the bolt (A) & (B).
Tightening torque:

24.5 - 29.4 N.m (2.5 - 3.0 kgf.m, 18.1 - 21.7 lb-ft)

[Front]

Fig 4: Disconnecting Brake Hose (Front)
Courtesy of HYUNDAI MOTOR AMERICA

[Rear disc]

Fig 5: Disconnecting Brake Hose (Rear Disc)
Courtesy of HYUNDAI MOTOR AMERICA

[Rear drum]

Fig 6: Disconnecting Brake Hose (Rear Drum)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the brake hose bracket by loosening the bolt (A). [Drum brake only]
Tightening torque:

18.6 - 25.5 N.m (1.9 - 2.6 kgf.m, 13.7 - 18.8 lb-ft)

Fig 7: Removing Brake Hose Bracket (Rear Drum Only)
Courtesy of HYUNDAI MOTOR AMERICA