LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Elantra Eco >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Driveshaft Assembly) >> Dynamic Damper >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
  2. Install the dynamic damper.
  3. Install the dynamic damper band.
  4. Using the SST (09495-39100), secure the TJ boot bands.
    Fig 1: Installing Dynamic Damper Bands Using Special Service Tool (09495-39100)
    G12025919Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Do not reuse the boot band.
  5. Install the TJ joint assembly.

    (Refer to Driveshaft Assembly - "TJ JOINT ")

  6. Install the front driveshaft.

    (Refer to Driveshaft Assembly - "FRONT DRIVESHAFT ")

  7. Check the front alignment.

    (Refer to Front Alignment - "ALIGNMENT ")

scientia non olet · About LEMON Manuals