Repair Procedures: Installation

Install the wiper motor.
Install the crank arm.
Install the linkage to the wiper motor crank arm.
CAUTION: To install the wiper motor crank arm (A), make sure that the linkage (B) is aligned with the crank arm in straight line and set the angle of each linkages exactly.
Be careful not to bend the linkage.

Fig 1: Installing Wiper Motor Crank Arm
Courtesy of HYUNDAI MOTOR AMERICA
Install the wiper motor and linkage assembly and then connect the wiper motor connector.
Tightening torque :

6.9 ~ 10.8Nm (0.7 ~ 1.1, kgf.m, 5.1 ~ 8.0 lb-ft)
Install the cowl top cover.
Install the windshield wiper arm and blade.
Tightening torque :

22.5 ~ 26.5 Nm (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.6 lb-ft)
NOTE:
- The windshield wiper motor must be cycled to make sure that it is in the auto stop position.
  If necessary, adjust the wiper arm and blade.
Install the wiper arm and blade to the auto stop position.
A: Auto stop position (Blade)

Fig 2: Installing The Wiper Arm & Blade To the Auto Stop Position
Courtesy of HYUNDAI MOTOR AMERICA
Set the cowl top cover on the specified spray position.
NOTE:
- When you turn on the washer, confirm 50% or more of washer fluid lands within the spray area.
- If the spray area is not within the standard positions, adjust the nozzle (s).

Fig 3: Cowl Top Cover On Specified Spray Position

Courtesy of HYUNDAI MOTOR AMERICA

SPECIFIED SPRAY POSITION MEASUREMENTS