LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Driveshaft Assembly >> Front Driveshaft >> Repair Procedures >> Reassembly

Repair Procedures: Reassembly

  1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boots.
  2. Assemble the transaxle side joint boot and bands.
  3. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
    Fig 1: Installing Spider Assembly & Snap Ring On Driveshaft Splines (1 Of 2)
    G12125212Courtesy of HYUNDAI MOTOR AMERICA
    Fig 2: Installing Spider Assembly & Snap Ring On Driveshaft Splines (2 Of 2)
    G12125213Courtesy of HYUNDAI MOTOR AMERICA
  4. Add specified grease to the joint boot as much as it was wiped away at inspection.
  5. Install the both boot band.
  6. To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
    TJ BOOT GREASE SPECIFICATIONS CHART

    Engine TM Distance (L) mm (in.)
    LH RH
    Gamma 1.6 GDI MT 546.1 (21.5000) 826.4 (32.5354)
    DCT 493.3 (20.5984) 878.8 (32.0866)
    Gamma 1.6 T-GDI MT 530.8 (20.8976) 518.0 (20.3937)
    AT 522.1 (20.5551) 537.8 (21.1732)
  7. Using the SST (09495-3K000), secure the TJ boot band.
    Fig 3: Securing TJ Boot Band Using SST
    G12125214Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals