LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Tucson SE, FWD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Control System - 2.0L >> Inhibitor Switch >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Make sure vehicle does not roll before setting shift lever to "N" position.
  2. Disconnect the negative (-) battery cable.
  3. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  4. Remove the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  5. Disconnect the inhibitor switch connector (A).
  6. Remove the shift cable mounting nut (B).
    Fig 1: Locating Inhibitor Switch Connector And Shift Cable Mounting Nut
    G12044656Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the manual control lever (B) and the washer after removing a nut (A).
    Fig 2: Removing Manual Control Lever, Washer And Nut
    G12044657Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the inhibitor switch (A) after removing the bolts (2 ea).
Fig 3: Removing Inhibitor Switch And Bolts
G12044658Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals