LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Plug-In Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 351 (MULTIFUNCTION Switch) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering wheel.

    (Refer to STEERING WHEEL Steering System )

  3. Remove the steering column upper and lower shrouds (A) after removing 3 screws.
    Fig 1: Locating Steering Column Upper And Lower Shrouds With Mounting Screws
    G12054321Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the light switch connector (A) and the wiper switch connector (B).
    Fig 2: Locating Light Switch Connector
    G12054322Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Locating Wiper Switch Connector
    G12054323Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the wiper switch (A) by pushing the lock pin (B).
    NOTE: When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.
    Fig 4: Pushing Lock Pin
    G12054324Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the clock spring.

    (Refer to Restraint - "DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING ")

  7. Loosen the screws (2 EA) from the multifunction switch assembly (A).
Fig 5: Locating Multifunction Switch Assembly With Mounting Screws
G12054325Courtesy of HYUNDAI MOTOR AMERICA