Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

Remove the battery and the battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the under cover (A).
Tightening torque:

7.8~11.8N.m (0.8 ~ 1.2 kgf.m, 5.8~8.7 lb-ft)

Fig 1: Removing Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.
Drain plug tightening torque:

38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

Fig 2: Removing Drain Plug
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Replace the gasket before reinstalling the drain plug.
Remove the wiring bracket installation bolt (A).

Fig 3: Removing Wiring Bracket Installation Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Remove the ATF Injection hole (eyebolt) (A).
Eyebolt tightening torque:

2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

Fig 4: Removing ATF Injection Hole (Eyebolt)
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Replace the O-Ring (A) before reinstalling the eyebolt.

Fig 5: Locating O-Ring Eyebolt
Courtesy of HYUNDAI MOTOR AMERICA
Remove the valve body cover (A).
Tightening torque:

(A) 13.7~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

Fig 6: Removing Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the gasket (A) before reinstalling the valve body cover.
Fig 7: Replacing Gasket And Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the oil temperature sensor connector (A).

Fig 8: Disconnecting Oil Temperature Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CAUTION: Be careful not to damage the harness lock connector.

Fig 9: Removing Oil Temperature Sensor
Courtesy of HYUNDAI MOTOR AMERICA