LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Plug-In Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Control System - 2.4L (Except HEV)) >> Injector >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2016 Hyundai Sonata and 2015 Hyundai Sonata. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Combustion Seal And Rubber Washer
G10573522Courtesy of HYUNDAI MOTOR AMERICA
  1. Combustion seal
  2. Rubber washer
  3. Support disc
  4. O-Ring
    CAUTION:
    • DO NOT reuse the used injector fixing clip.
    CAUTION:
    • Install the component with the specified torques.
    • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
    CAUTION:
    • Apply Engine oil to the injector O-Ring.
    • DO NOT reuse the used injector O-Ring.
    CAUTION:
    • DO NOT reuse the used bolt.
    CAUTION:
    • When inserting the injector, be careful not to damage the injector tip.
    CAUTION:
    • DO NOT reuse the support disc.
    • DO NOT reuse the injector rubber washer.
    • When replacing the rubber washer, the steel plate (A) part should face the cylinder head and the rubber plate (B) part should face the injector body part.
    Fig 2: Identifying Steel Plate And Rubber Plate
    G10573523Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • DO NOT reuse the combustion seal.
CAUTION:
  • When tightening the delivery pipe installation bolts, tighten them in accordance with the order ((2) (3) (1) (4)) after hand tightening.
Fig 3: Delivery Pipe Installation Bolts Tightening Sequence
G10573524Courtesy of HYUNDAI MOTOR AMERICA
  1. Installation is reverse of removal.
scientia non olet · About LEMON Manuals