Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
Remove the intake manifold.
(Refer to Engine Mechanical System - "INTAKE MANIFOLD ")
Remove the delivery pipe foam (A).

Fig 1: Removing Delivery Pipe Foam
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Fig 2: Disconnecting Rail Pressure Sensor Connector

Courtesy of HYUNDAI MOTOR AMERICA