Monitor GDS Data

WARNING: This page is about a different car, the 2016 Hyundai Elantra GT and 2015 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.

Monitor DTC Status
1. Vehicle Parked & Ignition ON.
2. Connect GDS and select "DTC Analysis" mode.
3. Click "DTC Status" on the DTC menu bar to view DTC's information.
4. Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
5. Read "DTC Status" parameter.
  
  Fig 1: Display - DTC Information Screen
  Courtesy of HYUNDAI MOTOR AMERICA
6. Is parameter displayed "Present Fault"?
  YES
  - Refer to: Next procedure.
  NO
  - Fault is intermittent caused by poor contact in the sensors and/or Control modules connector or was repaired and Control modules memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and Refer to: "VERIFICATION OF VEHICLE REPAIR " procedure.