LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Limited 2.0T >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.0L (Except HEV) >> Injector >> Repair Procedures >> Installation

Repair Procedures: Installation

Fig 1: Locating Combustion Seal, Rubber Washer, Support Disc And O-Ring
G11994408Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • Do not reuse the used injector fixing clip.
CAUTION:
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
CAUTION:
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
CAUTION:
  • Do not reuse the used bolt.
CAUTION:
  • When inserting the injector, be careful not to damage the injector tip.
CAUTION:
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the steel plate (A) part should face the cylinder head and the rubber plate (B) part should face the injector body part.
Fig 2: Locating Steel Plate Part Cylinder Head
G11994409Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • Do not reuse the combustion seal.
CAUTION:
  • When tightening the delivery pipe installation bolts, tighten them in accordance with the order (→ → →) after hand tightening.
Fig 3: Delivery Pipe Installation Bolts Tightening Sequence
G11994410Courtesy of HYUNDAI MOTOR AMERICA
  1. Installation is reverse of removal.
scientia non olet · About LEMON Manuals