LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Eco >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 1.6L (Except HEV) >> Electric WGT Control Actuator >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Lift the vehicle.
  3. Disconnect the EWGA connector (A).
    Fig 1: Locating EWGA Connector
    G11987327Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the exhaust manifold heat protector.

    (Refer to Engine Mechanical System - "EXHAUST MANIFOLD ")

  5. Remove the shaft link assembly (B) after removing the C-ring (A).
    Fig 2: Locating Shaft Link Assembly And C-Ring
    G11987328Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the turbo charger water pipe installation bolt (A).
  7. Remove the EWGA after removing the bolts (B).
    Fig 3: Locating Turbo Charger Water Pipe Installation Bolt And Bolts
    G11987329Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: When carrying the turbo charger, do not hold the rod of the turbo charge to prevent bending the rod.
scientia non olet · About LEMON Manuals