Repair Procedures: Removal
- Release the residual pressure in fuel line.
(Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
- Remove the rear seat.
(Refer to "REAR SEAT ASSEMBLY ")
- Remove the fuel pump service cover (A).
- Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
- Disconnect the fuel feed tube quick connector (C).
- Remove locking ring (A) by using the special service tool.
Information
The locking ring should be removed by a locking ring remover as below.
This tool can be purchased from a common tool supplier.