Repair Procedures: Replacement

Remove the rear hub bearing assembly.
(Refer to Driveshaft and Axle - "REAR HUB/CARRIER ")
Remove the sensor cap (A).

Fig 1: Removing Sensor Cap
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- When removing the sensor cap, remove by hammering the gap between the sensor cap and hub bearing assembly using the scraper (A).
  
  Fig 2: Removing Sensor Cap
  Courtesy of HYUNDAI MOTOR AMERICA
- To widen the gap little by little, hammer around the bearing cap over 10-20 times.
  
  Fig 3: Locating Bearing Cap
  Courtesy of HYUNDAI MOTOR AMERICA
- When using the hammer, be careful not to damage the hub bearing assembly.
  
  Fig 4: Hub Bearing Assembly
  Courtesy of HYUNDAI MOTOR AMERICA
- When alternately tap the gap between the various places with the mallet.
Install the sensor cap (A) with the special service tool (SST No.: 09527-2W100, 09231-H1100).

Fig 5: Installing Sensor Cap
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Before installing the sensor cap, do not let any foreign material and contaminant inside the hub bearing assembly.
  
  Fig 6: Installing Sensor Cap
  Courtesy of HYUNDAI MOTOR AMERICA
- Hammer until there is no gap between the SST and hub bearing assembly and install the sensor cap.
Fig 7: Installing Hub Bearing Assembly (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 8: Installing Hub Bearing Assembly (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA